|
Normally , taking this to the dealers can be very expensive. A new WSP (immo box) and possibly and new ECU would be required and would need coding.
This can happen whilst trying to jump start you van.
We can repair this start error and get your vehicle working again.
As we are repairing your original components you will not need to code the components back to the vehicle.
All your vehicle data will remain the same like the Vin, mileage and other factors.
You will need to send in :
- Your existing key
- ECU (normally mounted behind/underneath the glove compartment)
- WSP (clamped to the back of the instrument cluster)
MERCEDES SPRINTER START ERROR REPAIR ONLY !
WE DO NOT SUPPORT THE MERCEDES VITO START ERROR
Whilst you are sending in your components you might consider having your vehicle remapped and get a spare key
It is important that you remove the key before attempting to remove any components ! It is advisable to disconnect the battery when removing or re-fitting the components.
It is important that you have two +12V supplies to yor WSP please check as in the diagram below before sending. Contact us if you do not have the supplied there.
Pin 3 is battery +12V , Red/Yellow Wire
Pin 7 is ignition +12V, Black /Yellow Wire
Component Location
ECU is mounted behind/underneath the glove box
WSP is attatched to the rear of the instrument cluster
Your ECU , WSP and Key will be sent back ready to start your vehicle.
 
 
|
