Sensotronic Brake Control (SBC)

If you own a Mercedes E Class W211 or SL R320 and have a brake error, then you must replace the SBC unit which can be very expensive from the dealer.

The SBC module counts breaking cycles, after exciting the value of approx 300000 , an error message occurs.

It's a kind of protection for the electro motor inside the aggregate.

So far we had no problems, we've tested the first module over 6 months ago, reset this and reused in a car sucessfuly. 

This is an exclusive service by Revtronic, carried out at our workshop. As many claim that a new unit must be fitted.

The SBC will have to be removed and sent into us.

The unit has to be disabled before removing.

Errors reported :

SBC Control module failure

STOP

Brake defective stop vehicle (Normally dispalyed on the screen)

OPERATING TIME OF COMPONENT A7/3 IS EXCEEDED (SBC HYDRAULIC UNIT) ON A W211 MERCEDES E220 CDI FAULT CODE IS C249F

We have successfuly repaired the following Bosch Part Numbers :

Here is the location :

There is a special procedure to remove the SBC unit.

Please take your car to a qualified technician.

If uncertain on how to remove the SBC unit , please contact us.

Please contact us if your part number is not listed